Home | Products | Load Cell Signal Conditioning | TMO-1-24 Load Cell Signal Conditioner

LOW COST 24 VDC POWERED AMPLIFIER / CONDITIONER MODULE

MODEL TMO-1-24

The TMO-1-24 Module provides low cost dedicated conditioning for one bridge type load or pressure sensor. Several units can be powered from a common power supply. The TMO-1-24 requires a 24 VDC input source. The units provide balance and span adjustment via precision 10 turn pots. Full scale output is specified at plus or minus 8 VDC. The TMO-1-24 provides a floating shunt calibration circuit which applies calibration at the transducer, thereby eliminating errors due to line losses. The factory set bandwidth is 220 Hz. The TM0-1-24 can be ordered with a 2200 Hz bandwidth for dynamic applications and a 2.2 Hz or 22 Hz to improve stability in applications where noise is an issue.

TMO-1-24 Signal Conditioner Manual

Discontinued Item - See replacment links below

LCA-9PC Load Cell Amplifier Signal Conditioner with DB9 Connectors

LCA-RTC Load Cell Amplifier Signal Conditioner with Removable Terminals

Specifications

AMPLIFIER SECTION
	Type:	Bipolar, differential
	Gain Range:	75 to 1000
	Input Sensitivity:	1 mV/V minimum for 8 VDC output
	Output Voltage:	0 to ±8 VDC (linear to 9.5)
	Output Current:	0 to 10 mA
	Nonlinearity:	.01% maximum
	Accuracy:	±.05% of FS
	Stability:	±.1% for 24 hours
	Tempco:	.01% full scale/°C
	Noise and Ripple:	Less than 5 mV P-P at gain=1000
	Filter Type:	2 Pole Butterworth
	Frequency Response:	DC to 220 Hz (2.2, 22, 2200 Hz available, no charge)

BRIDGE SECTION
	Excitation Voltage:	8 VDC ±.25 V 5 VDC optional
	Sensor Resistance:	120 ohm minimum 1000 ohm maximum
	Balance Range:	±30% of output (350 ohm bridge)
GENERAL
	Weight:	Approx. 2 oz
	Size:	2.25"L x 2.50"W x .80"H inches tall
	Mounting:	Corner standoffs, 4-40 thread
	Input/Output:	Via screw terminals
	Operating Temp:	0 to 70 °C
	Power Required:	24 VDC ± .5V at 65 mA
	Mounting Footprint:	2.020 x 2.280