Print Load Cell Items
Made in USA

MODEL PHM-100

The PHM-100 is a portable hand-held digital indicator for strain gage bridge type transducers such as load cells, torque sensors and pressure sensors. It provides bridge excitation, balance, span adjustment, shunt calibration, decimal point selection and digital display. When peak hold is in the on position, the highest static or dynamic signal is captured at less than one millisecond and displayed until reset. The PHM-100 operates on a standard 9 volt battery for 60 hours and is equipped with a low battery Indicator.

PHM-100 is a portable hand-held digital indicator.

Discontinued Item - See replacment links below

Specifications
SIGNAL CONDITIONER 
Type: Full external bridge
Sensor Resistance: 350 to 1000 ohm
Balance Range: 20% of FS
Shunt Calibration: Push button, single point, shunt resitance of 87.325 Kohm
BRIDGE AMPLIFIER 
Type: Bipolar differential
Input Sensitivity: HIGH: 2mV for 19999 count min. LOW: 20mV for 19999 counts min (via Gain switch)
Display Scaling: 0 to 19999 counts
BRIDGE EXCITATION 
Type: Constant voltage
Output: 1.21 VDC
Output Current: 15 mA, short circuit protection
PEAK CAPTURE 
Type: Analog
Response Time: Less than 1 ms
Zero Reset: .05% of fill display Count
Drop Rate: .15% / minutes max (approx 25 counts as FS)
Capture Sense: Bidirectional (via polarity switch)
GENERAL 
Nonlinearity: 1 count FS
Accuracy: ± .1% of FS
Tempco: 7ppm / °C max
Noise: 2 counts max
Balance Stability: .2% for 8 hours
Gain Stability: .02% for 8 hours
Operating Temp: 0° to 50°C
Size: 5.7 x 3.1 x 1.5 inches
Weight: .6 lbs. approx
Connector: 9 pin D sub male
Power: 9 VDC battery for 60 hours low battery annuniciator

Discontinued Item - See replacment links below

Discontinued Item - See replacment links below


OPT-TEDS Plug & Play Option

AD9 (9 PIN "D" Series) Connector attached to the end of a Load Cell or Torque sensor cable with a TEDS (Transducer Electronic Data Sheet) EEPROM. Used with a Smart Plug & Play IEEE 1451.4 Compliant instrument, (shown on right), the Load Cell and Instrument will self calibrate. This option is a real time saver. Read additional article...
cal-teds plug and play option
Smart Load Cell Plug and Play Systems
Learn about Plug & Play Smart Load Cell Systems.
SST Transmitter
SST-HV High Voltage Load Cell Transmitter
Plug & Play Smart Load Cell Transmitter
IEEE 1451.4 Compliant
High Voltage 85-265 Vac
$475.00
»More info
SST Transmitter
SST-LV Low Voltage Load Cell Transmitter
Plug & Play Smart Load Cell Transmitter
IEEE 1451.4 Compliant
Low Voltage 10-48 Vdc
$510.00
»More info
SSI Portable Hand-Held Load Cell Indicator
SSI Portable Hand-Held Load Cell Indicator
Ultra-Fast 15 kHz Plug & Play Smart Hand Held
Indicator With Data Logging
IEEE 1451.4 Compliant
$950.00
»More info
DPM-3 Panel Mount Load Cell Display
DPM-3 Panel Mount Smart Load Cell Meter
Plug & Play Smart Digital
Panel Mount Load Cell Meter
IEEE 1451.4 Compliant
$570.00 to $625.00
»More info